In this article we’re going to look at how to make your own dog mask. We’ll cover the basics and then go on to take a look at some of the more advanced tips and techniques that you can use.
If you have a dog that likes to bark, and particularly if your dog loves to play in the garden and other areas of the home, you need to get them some special dog protection.
Paper Plate 3d Dog Mask DIY Materials: This is the initial part of the setup which will look a little scary at first, but it’s actually quite straightforward. All you have to do is take a cardboard cutting board and cut the cardboard into the shape of your mask. You can not simply cut a rectangular shape from the cardboard, so you will need to cut around the edge of the mask so that you get something which resembles a cone. The main thing here is to be realistic with what type of paper plate which you’re using.
Then you’ll have to wrap the cardboard around the edges of the paper plate, making sure there is a good seal between the two pieces so that you can ensure that nothing will leak when you place the mask on. Be sure that the edges are cut so the edges aren’t sharp, as this may damage the edges of the mask.
Glue it on! The next step involves using some paint. You should spray the paint over the cardboard, making sure that it runs smoothly and evenly across the entire mask. You will want to start with one side of the mask , so that you can work your way around it before moving onto the other side. The paint has to be slightly thicker than the cardboard, and it is best that you leave about one-third of an inch of paint on the edges so that it runs over the cardboard.
Don’t worry too much about the paint getting stuck into your mask. It’s easy to eliminate it later, and it’ll leave you with a wonderful finished mask to show off to everyone! It’s also a good idea to wipe away any excess paint once you are done, so that you don’t end up with smudges or smears on your dog.
Then it’s time to paste the mask on your dog’s head. First you will need to make sure that you get a secure fit between the mask and your dog’s head. Once puppy dog mask you’ve made sure that it’s secure, then you may begin to glue the mask on the dog’s face. Take the piece of cardboard that is used for the foundation of the mask and fold it over. Be sure that it’s quite strong and then use your hands to ensure the cardboard down in place.
Keep your hands out of the way and use tape to hold it in place as you repeat the procedure on the cardboard folds till you have the mask snugged firmly onto the surface of your dog. Don’t make the folds too large or else it could look messy. Once you’ve completed this, you can then take out the mask and then attach the cardboard ears. And attach the other area of the mask onto the dog. Be sure the ears are flat and make sure that it’s not too short or long as this can cause some problems with the mask slipping off the dog’s face.
If you are using a dog mask because your dog protection, you’ll have to do some sanding to make sure that it is safe on your dog. You can do this by sanding off any excess paper that may have been removed from your mask.